MATERIAL
SAFETY DATA SHEET
I - PRODUCT AND COMPANY
IDENTIFICATION
|
Dr. Graffiti |
Daytime Phone: 1-866
730-3303 |
1 |
HEALTH |
|
|
3303 N. San Fernando Blvd |
|
0 |
FIRE |
|
|
BURBANK, CA
91504 |
Emergency Phone: 1-800-255-3924 |
0 |
REACTIVITY |
|
|
USA |
|
B |
MAX. PERSONAL PROTECTION |
|
A=
Goggles B= Goggles &
Gloves C=Goggles, Gloves, Apron
4=
Extreme 3= High 2= Moderate 1=Slight
0=Insignificant
|
|
|
Date: |
27-Oct-03 |
Revision
Date: |
27-Oct-03 |
||
|
Product
Name: Description du produit: |
DR. GRAFFITI AMIGO |
Product
Description: |
Graffiti
Remover |
||||
|
WHMIS
Classification: |
D 2 B |
Transport
Information: Not Regulated |
|
||||
II
- COMPOSITION
|
Ingredients |
CAS # |
% |
PEL |
TLV |
LD50 Oral |
LC50 |
|
This MSDS is prepared to comply with OSHA
Hazard Communication Standard (29 CFR 1910.1200). Unlisted ingredients are
not "Hazardous" per this standard and are considered proprietary.
Identities of proprietary ingredients will be made available following
procedures specified in the standard. Physical Hazard: None |
||||||
III - PHYSICAL DATA
|
Physical State: |
Liquid |
|
Vapor Density (air = 1): |
N/Applicable. |
|
Appearance/Color |
Yellowish – Amber |
|
Solubility in water (%): |
Complete |
|
Odor: |
Characteristic |
|
Evaporation Rate (Butyl Ac =1): |
Dispersible |
|
Odor Threshold (PPM): |
N/Applicable. |
|
Boiling Point: |
Not established |
|
Specific Density (water = 1): |
< 1.05 |
|
Freezing Point: |
> 100 deg C (212 deg F) |
|
Vapor Pressure (mm Hg): |
N/Applicable. |
|
% volatile by volume: |
approx 33% |
|
pH (as is): |
12-14 |
|
VOC Content: |
NMT 400 gms/liter. |
IV
- FIRE AND EXPLOSION HAZARD DATA
|
|
|
|
|
|
Flammability: |
Not flammable |
Auto-Ignition Temperature: |
Not Available |
|
Flash Point (°C): |
>93.3 °C |
Explosion Data: |
Not Applicable |
|
Flammable Limits: |
Not Applicable |
Extinction Media: |
Water spray, carbon dioxide,
dry chemical and foam. |
|
Special
Fire fighting Procedures: Containers exposed to fire should be kept cool. W ear protective clothes. Use canister
mask or
self-contained breathing apparatus and recommended technique to fight main
cause of fire. |
|||
V - REACTIVITY
Stability: … Stable
Incompatible Materials: … Acids, corrosive material,
oxidizers, bases
Hazardous Decomposition Products: … Thermal
decomposition may generate carbon oxide.
Conditions to avoid: … Excessive heat and freezing.
Hazardous Polymerization: … Will not occur
VI - TOXICOLOGICAL DATA
Routes of Entry and the effects of acute exposure:
Eyes …
Contact may cause a mild irritation and redness of the eyes
Skin … May cause skin redness, rash, and
irritation on repetitive and prolonged contacts
Ingestion … Gastro- intestinal irritation, nausea,
vomiting abdominal cramps
Inhalation …
May irritate respiratory system and provoke dizziness
|
Effects of Chronic Exposure: |
See Above |
Reproductive Toxicity : |
No reproductive effect known |
|
Irritating Properties: |
See Above |
Teratogenic effects: |
No teratogenic effect known |
|
Sensitization of product: |
Non Available |
Mutagenic effects: |
No mutagenic effect known |
|
Carcinogenic efects: |
No carcinogenic effect
known |
Synergistic Materials: |
Not Available |
VII
- PREVENTIVE MEASURES
Room Ventilation: … Use adequate local ventilation.
Forced or mechanic ventilation not required.
Protective
Equipment:
Respiratory: … NIOSH-MSHA approved respirator if air contamination exceed the
permissible level.
Eyes: … Chemical
goggles and full face shield
Gloves: … Acid
resistant gloves are recommended.
Footwear: … Rubber
boots (optional).
Other … Eye washing fountain (recommended)
Storage Requirements: … Store in a cool and dry place. Keep in tightly
closed containers after usage.
VIII
- HANDLING PROCEDURES
Handling Procedures: … Avoid contact with eyes,
skin, and clothes. Avoid ingestion and inhalation of product
Spill or Leak Procedures: Forbid access
to the area. Wear protective clothes as required. Confine spilled product to
prevent environmental contamination. Avoid product penetrating sewers and
waterways. Pump liquid into a container or absorb with absorbent material.
Rinse with water and wipe to prevent slippery. If product is spilled in
environment, advise immediately local, provincial or federal authorities as
required by law.
Waste
Disposal Information: Dispose
of in accordance with local, provincial and federal regulations.
IX - FIRST AID AND EMERGENCY
PROCEDURES
In case of contact with eyes: … Flush eyes immediately with running water for
at least 15 minutes while holding eyelids open. If irritation persists, get
medical attention.
In case of contact with skin: … Wash skin with water and soap for at least 15
minutes. Remove contaminated clothes. If irritation persists, get medical
attention.
In case of ingestion: … Contact a physician immediately. Do not induce
vomiting. If conscious, give a lot of water in order to dilute the product.
Never give anything by mouth if person is unconscious.
In case of inhalation: …
Move person to fresh air. If
difficulty in breathing persists, contact a physician immediately.
X - REGULATORY INFORMATION
1. US
Federal regulations: This material or
its components are listed on or are in compliance with the requirements of
the TSCA Chemical
Substance Inventory.
2. Canadian
regulations:
CEPA
(Canadian Environmental Protection Act); All ingredients NOT confirmed on the
DSL (Domestic Substances List).
3. We assigned HMIS ratings to this product based on the known hazards of its ingredients. This information is furnished without expressed or implied warranty, representation, inducement or license of any kind, except that it is accurate to the best of our knowledge or is obtained from sources believed by us to be accurate. We do not assume any legal responsibility for use or reliance on same. Customers are encouraged to conduct their own tests. Before using any products, read the label.
4.
Prepared by:
Doctor Graffiti Canada
5. Date of preparation: February 2003